Applies to: DT41Y/DT61Y/DT81Y/DN41R/DN61R/DN81R/DT41GB/DT81GB/DT61GB/DT41DB/DT81DB/DT61EQ/DW41JD/DW81KD/DW61LD/DT81DP/N48PI/N44PI/N46PI/N44PAM/N48PAW/N46PCK/N88PCH/N441Y/N481Y
Introduction: Restoring default settings means that the device's factory settings, such as the boot interface, standby mode, operation shortcuts, etc., will be restored to the original look of the device.
Please use this function with caution.
Before you start: You should log in to your DVR/NVR
Steps:
- Click Menu > Maintenance > Default, and enter into the Default interface.
- Select the restoring type from the following three options.
- Restore Defaults: Restore all parameters, except the network (including IP address, subnet mask, gateway, MTU, NIC working mode, default route, server port, etc.) and user account parameters, to the factory default settings.
- Factory Defaults: Restore all parameters to the factory default settings.
- Restore to Inactive: Restore the device to the inactive status.
- Restore Defaults: Restore all parameters, except the network (including IP address, subnet mask, gateway, MTU, NIC working mode, default route, server port, etc.) and user account parameters, to the factory default settings.
Note: The device will reboot automatically after restoring to the default settings.
Comments
0 comments
Article is closed for comments.