Adding Device to Annke Vision by Scanning QR Code

Applies to: DT41Y/DT61Y/DT81Y/DN41R/DN61R/DN81R/DT41GB/DT81GB/DT61GB/DT41DB/DT81DB/DT61EQ/DW41JD/DW81KD/DW61LD/DT81DP/N48PI/N44PI/N46PI/N44PAM/N48PAW/N46PCK/N88PCH/N441Y/N481Y

Purpose:

You can add the device by scanning the device's QR code.

Before you start:

• Activate your device before adding.
• Make sure the device is powered on

Steps:

1. On the Annke Vision page, tap .
   
   
   
2. Tap Scan QR Code to enter the Scan QR Code page.
   
   
   
3. Scan the device QR code by aligning the QR Code with the scanning frame.
   Note 1: Normally, the QR code is printed on the label, which is attached to the device.
   Note 2: If there are device QR codes in your local album, tap  to extract QR code from the local album.
   Note 3: Tap    to enable the flashlight if the scanning environment is too dark.
   
   
   
   
4. Tap Add in the Result page.
   
   
   
5. The adding is completed.
   
   
   
6. (Optional) You can edit the device information if needed.