Applies to: N48PI/N44PI/N46PI/N44PAM/N48PAW/N46PCK/N88PCH/N441Y/N481Y
You can use SNMP protocol to get device status and parameters related information.
- Enter the Network Settings interface. Menu > Configuration > Network.
Select the SNMP tab to enter the SNMP Settings interface, as shown below.
- Check the SNMP checkbox to enable this feature.
- Configure the following SNMP settings:
Trap Address: IP Address of SNMP host.
Trap Port: Port of SNMP host.
Click the Apply button to save and exit the interface.
Before setting the SNMP, please download the SNMP software and manage to receive the device information via SNMP port. By setting the Trap Address, the NVR is allowed to send the alarm event and exception message to the surveillance center.