Factory/Password Reset I51DM Turret Camera

Follow
Richard Rogers

Hi,

Just bought a brand new I51DM camera and located it on my network using the SDAP software so I could configure it. However, it's status is "Active" so I can't setup a password for it.

Is there a way to factory reset this camera so I can actually configure it?

Thanks,

Richie

0

Comments

3 comments

Date Votes
  • James N

    You will need to look at the camera body and where you enter the Micro SD card there should be a Reset to Factory Switch. You would need to press this until you hear the Camera Click *Normally the IRC filter* will click if it has one anyway. I don't know that camera so I can't say that it can work in that way or not.. I know that All IP cameras I own have a Reset button on/in the cameras body for being able to Reset the Camera to Factory defaults. Right now don't use the camera on a granted internet line because of the user before you still has it connected to their Annke Vision App they can see the camera. However if it is connected to your NVR POE port this isn't always the case. Unless your NVR is working like one of my Pro Versions does where it works in Bridge Mode POE then that NVR POE ports uses my Networks normal IP range and not one from the NVR.. Not sure if Annke has a NVR like that but just wanted to make sure I put that out there incase your NVR in fact was setup that way on the POE ports.. 

    Be Safe.. 

    -1
    Comment actions Permalink
  • Richard Rogers

    Hi James,

    There was a little plate underneath that I had to unscrew and there I found the reset button.

    Device is now reset and "Inactive" so I can configure it.

     

    Thanks,

    Richie

    0
    Comment actions Permalink
  • James N

    Awesome glad to hear you got it sorted on the Reset, Now with SDAP get it setup for your network and your needs. Be safe. 

    James

    0
    Comment actions Permalink

Please sign in to leave a comment.

Didn't find what you are looking for?

New post