How to Install a Hard Drive (HDD) in the DVR/NVR?

Purpose:
This article provides step-by-step instructions on how to install a hard drive (HDD) in your DVR/NVR system.

Before You Start:

Before installing the hard drive, please make sure to power off the system.

Here is a helpful video showing how to install a hard drive:
👉 https://www.youtube.com/watch?v=Kpy480TtX7E

You can also follow this video to remove the old hard drive from your DVR.

Installation Steps:

1. Loosen the five screws securing the DVR cover.

2. Push the cover forward and remove it.

3. Connect the hard drive to the DVR system.

4. Power on the DVR and check if the hard drive is detected. Then power off the system again.
Note: The interface may vary slightly depending on the model.

5. Secure the hard drive inside the DVR using the provided screws.

6. Reinstall the cover and fasten it with screws.

7.Format the HDD when using it for the first time.
For details, please refer to:
👉 https://help.annke.com/hc/en-us/articles/360000480281

Notice:

For any other questions, feel free to contact ANNKE Technical Support :

support@annke.com