Annke Vision - How to Set Up 24 Hours Recording? (AI Detection NVRs)

Applies to:
N48PAW/N46PCK/H800/H500

Purpose:
You could setup a continuous (24 hours * 7 days) recording schedule for the system. Please make sure there is an HDD (Hard Disk Drive) inside the ANNKE system before recording. Without the hard drive, the system can show live view, but can’t record, playback either.

Steps:

1. Confirm the HDD status.
Newly installed hard drive needs to be initialized/formatted. Please Init the hard drive on the ANNKE system like the picture below.
To do so, login to the system on a connected TV/monitor, navigate to the menu page Setting--Record--Storage.
When the HDD status is R/W, it is ready for video recording.

2. Set up Recording.

Please notice that the system is set to record continuously. If nothing changes you can directly leave it as default. To check it, please navigate to Setting--Record--Schedule:
Please directly enable the schedule first, then click the Continuous, then drag the time in the schedule.
You could also click the Edit to select the recording time.

After that, the blue bar will be shown on the record page. That means you have set up the 24 hours recording.

3. When finishing the setting for one channel, you can also click Copy to to apply same settings on other channels.
Or you can click on Camera No. to select different channel and set up one by one.

When you see the red movie icon on the camera channel, that means this channel is recording.