Annke Vision -- How to Setup the 24 Hours Recording? (AI Detection DVR)

Applies to: DW81KD/DW61LD/DW41JD/S500/S300/FC200

Purpose: The article will introduce how to continuous recording. Please note that this instruction only works for the AI Detection DVR.

Before you start the setting:

Kindly please confirm that you have installed the HDD inside the box. If not, kindly please follow the guide here:
https://help.annke.com/hc/en-us/articles/360000249441

Steps:

1. Confirm HDD status.

When confirmed HDD is successfully installed HDD inside the box, you can check the HDD setting.
Please go to Setting-->Record-->Storage device" to check the status. If the status shows "R/W", that means the status is normal.

If the HDD status is "Error" or other messages, you can format it to make it work normally:

2. Set up Recording.

Please notice that the system default setting continues recording. If nothing changes you can directly leave it as default. Please go to Setting-->Record-->Schedule-->Record":
Please directly enable the schedule first, then click the Continuous, then drag the time in the schedule.
You could also click "Edit" to select the recording time.

After that, the blue bar will be shown on the record page. That means you have set up the 24-hour recording.

3. When finishing the setting in one channel, you can directly click "Copy to" to all channels.
You could also set up the camera one by one.

4. Five minutes after you set up the video schedule, you could go to the playback screen to see if there is a video to playback.