Applies to:
camera:I51CE
DVR:N46PCK/N48PAW/N88PCH/N931BB/N44PAM/N96PBD
Purpose: Adding a WIFI camera to Annke's poe NVR
Here are the steps:
1. Please connect the camera to a 12V DC power supply (must be 12 Volt, can be 1 Amp or above) and to a broadband router by ethernet cable.
2. And then, please visit the camera via the web first. Here is a link for your reference:
Annke Vision -- How to Access the Web interface of ANNKE PoE Cameras via Browser? (Without NVR)
Please take down the camera's IP address like this picture shows.
3. Please click configuration>network>advanced settings>WI-FI>Please click enable>choose your Wi-Fi in the wireless list>please input the information of your WIFI>click save.
4. Please connect your NVR to your router by using a network cable. After that, you can find the NVR is detected by the sadp Tool. Please double click the ip address>input the username and password of the NVR.
5. Please go to configuration>camera management>ip camera>you can find that the camera is detected by the NVR>please select it>click modify.
7. Please go to input the ip address of the camera>please choose IPCAM in the Protocol>input the activation password of the camera>select Manual in the Adding Method>click ok.
7. After that, you can find the I51CE camera shows online. You can go to go to 'Live View' to see the image of the camera.
8. After that, you can disconnect the network cable between camera and router.
If you have any other questions, please contact ANNKE technical support at support@annke.com by email.
Comments
0 comments
Article is closed for comments.