Applies to: C61H/C11H
1. Connect camera‘s female power cord to male power cord of long cable;
2. Connect camera‘s female BNC video cord to male BNC video cord of long cable;
3. Connect camera‘s RS485 cord to RS485 cord of long cable;
4. Connect long cable‘s female power cord to a power source;
5. Connect long cable‘s female BNC video cord to DVR‘s BNC video-in port;
6. Connect long cable‘s female RS485 cord to joystick‘s RS485-in port
7. set protocol and baud rate
Baud rate: 1200bps、2400bps、4800bps、9600bps、19200pbs、38400pbs
Protocol:Pelco-D 、Pelco-P 、SAMSUNG、AD、PANASONIC
Finally, you can use the joystick to move the camera.
If the joystick cannot move the camera,
1. check if RS485‘s positive and negative is opposite
2. notice if the camera spin by itself when it gets power. if not, the camera is broken.
3. check if protocol and baud rate are correct.
Comments
0 comments
Article is closed for comments.