Applies to: N44PS/N48PS/I61FB/I61FC/I61DT/I61DU/I81FB
The POE IP camera must support onvif protocol.
1. Prepare a 12V/2A power supply for the camera.
2. Power on the camera by a 12v/2a power supply, connect the POE camera to the same router which connected to the computer.
3. Access the POE IPC‘s setting page on the computer by the following link:
http://support.annke.com/kb/index.php?action=artikel&cat=26&id=211&artlang=en
4. Please go to configuration-advanced configuration-security-uncheck enable illegal login lock. This is very important!
Then pls back to the SADP tool, check the camera IP, and don‘t check the Enable DHCP, and change the camera‘s IP into 10.1.1.X.
Connect POE onvif camera to the POE NVR.
Connect camera to NVR‘s POE port directly.
There is two methods to add the camera into the NVR.
A. Search-add
B. Manual-add
A. Go to menu-setting-remote to detect camera‘s IP.
B. Pls go to setting-remote.
Comments
0 comments
Article is closed for comments.