Annke Vision - Set up Motion Detection on Annke DVR/NVR

Applies to:DT41Y/DT61Y/DT81Y/DN41R/DN61R/DN81R/DT41GB/DT81GB/DT61GB/DT41DB/DT81DB/DT61EQ/DW41JD/DW81KD/DW61LD/DT81DP/N48PI/N44PI/N46PI/N44PAM/N48PAW/N46PCK/N88PCH/N441Y/N481Y/NCK800/H800/H500

Purpose:

Enabling motion detection can trigger certain channels to start recording, or trigger full-screen monitoring, audio warning, notifying the surveillance center, sending an email and so on.
You can enable the function and set it up.

Before you start: 

• You should log in to your DVR/NVR.
• Click Menu>Camera>Motion

Enter the Motion interface and Configure Motion Detection.

• Camera: Choose a camera you want to configure.
• Enable Motion Detection: Tick the checkbox to enable motion detection.
• False Alarm Filter: Tick it to enable RIP function.
• Sensitivity: Slide the progress bar to the right to adjust the sensitivity of motion detection.
• Full Screen: Set the motion detection for all the area shots.
  
  Note: You can drag and draw the area for motion detection by mouse.
• Clear: Clear the motion detection area.
•  Settings: Select the trigger channels, Set the arming schedule, and linkage action according to your needs.
  •   Trigger channels: select the channel you want to set up.
  •   Arming schedule: set up the arming schedule.
  •   Linkage action: enable or unable the linkage action.
     
• Apply: Click Apply to save the setting.
• OK: Click OK to exit this page.
• Copy:  Click it to copy to other channels you want.