Applies to: N48PI/N44PI/N46PI/N44PAM/N48PAW/N46PCK/N88PCH/NCK800/H800
Purpose: Sometimes you though the environment is not too dark the system already switches to the IR model, It is not delighted with the B&W image, so you can follow the guide to do some setting.
Note: The IR is used for night vision. The system will auto switch the IR on/ off basic the environment. If the environment is too dark to get a clear image by the sensor, and the system will auto switch it to the night version(B&W image). If the light is enough for the sensor, It will auto switch back to the color model.
Here are the steps for you:
- Take a computer in the same network with the NVR. Then go to the NVR Menu--Configuration--Network--General to check the NVR IP address.
- Load the IP address in your computer IE browser, then go to the Configuration--Network--Advance settings--Others, then tick on the "Enable Virtual Host".
- Go to Configuration--System--Camera Management, you can find there is a URL for the cameras. Click it you can directly go the camera setting page.
- Go to the camera's settings page, and then go to the Configuration--Image--Day/Night Switch.
Please notice the Day/Night Switch model, you can select with the different models.
Auto: Auto-switch the model base on the environment light
Day: Keep in the color model
Night: Keep in B&W image
Scheduled-switch: You can set up the time for the model switch
Comments
0 comments
Article is closed for comments.